Motion 300 (odnowiony)

Motion 300 Speaker 60 cm USB-C to C Cable Safety Card&Quick Start Guide Note: Wall charger not included.

No

No, however, Motion 300 can pair with another Motion 300 speaker via TWS.

13-hour battery life is based on measurements taken at 50% volume and with Bass Mode off. The actual battery life may vary depending on factors such as the type of content being played, custom EQ settings, and volume level.

Motion 300 supports IPX7 waterproofing, but before submerging it in water, it is necessary to ensure that the waterproof cover is sealed tightly.

It takes around 4 hours to charge with a certified 5V/3A (15W) wall charger.

When charging, the power indicator light stays red. When fully charged, it stays white.

The recessed design make it easy to use the button in low-light and dark environments.

Motion 300 has two 15W full-range speakers.

30W

Turn on the speaker then hold down the "Bluetooth" and "Volume +" buttons for 5- 10 seconds. You'll hear a prompt and the speaker will automatically restart.

Yes. Motion 300 is equipped with a microphone, located on the top left.

Bluetooth 5.3.

Motion 300 supports LDAC, SBC, and MPEG2 AAC LC Bluetooth codecs.

Here are some tips on how to improve battery life: 1. Do not completely discharge the battery before recharging. 2. Recharge the battery as soon as possible when the low-battery indicator is on. 3. Stop charging once the battery is fully charged (to minimize recharging cycles). 4. Do not expose the speaker to harsh environments with extremely hot or cold temperatures. 5. Recharge the speaker regularly (once every 3 months) if it has not been used for a prolonged period.

1. Open the soundcore app and go to 'Update Firmware'. 2. Do not use your phone while the firmware is updating, except if you've set the soundcore app to run in the background. 3. Motion 300 will restart automatically after updating.

The speaker can recognize its own position (such as standing, lying, hanging), and automatically change the EQ to deliver the best possible sound for that situation.

Hi-Res is an abbreviation for High Resolution Audio, which is an audio format with superior sound quality that retains more audio detail. Hi-Res allows you to better enjoy music with Motion 300.

LDAC is a Bluetooth encoding format that can transmit 3 times the amount of data of the ordinary SBC Bluetooth codec. Note: LDAC only works on devices running Android 8.0 or above; it does not work on iPhone.

LDAC affecting Bluetooth performance is a common issue. However, as long as there is little interference around and the Bluetooth device is not far from the speaker, Bluetooth should work properly.

TWS stands for True Wireless Stereo, and it allows two identicial speakers to play stereo sound after pairing up. Motion 300 supports TWS.

Method 1 1. Speaker 1 and Speaker 2: Long press the power button to turn on both speakers. 2. Speaker 1: Hold the Bluetooth button until the button light flashes white. 3. Speaker 2: Hold the Bluetooth button until the button light flashes white. 4. Wait for a few seconds, and you will hear a sound when the two speakers have paired successfully. 5. The primary speaker is the one with the blue light. 6. Use the primary speaker to pair with your device. Method 2 1. Long press the power button to turn on both speakers. 2. Connect either speaker with your Bluetooth device. 3. On both speakers, press and hold the Bluetooth button for at least 2 seconds to enter TWS pairing mode. 4. Wait for a few seconds, and you will hear a sound when the two speakers have paired successfully.